Glass Tempering Insights: Latest News

Sometimes, you may find that the particle size of tempered glass does not meet the standard. What should be done at this moment? 1. If the tempering air pressure during the tempering cooling process is too low, it will cause a larger particle size. At this moment, we can increase the tempering air p

1.Due to the contact between glass and ceramic rollers, the expansion speed of the lower surface of the glass is greater than that of the upper surface after entering the furnace. The glass will bend and deform upwards, and the glass plate will be suspended around, with only the middle part in conta

1. How to find if the heater wire broken or not?Measure the resistance value between the phase wire screw of heater and N row using a low ohm range of an multimeter. If the wire is not burned, the normal resistance value should be less than 10 Ω. If the resistance value is the maximum value, it mean

If there is any heating wire of glass tempering furnace is broken, it needs to be replaced asap, otherwise it will affect the quality of tempered glass. You can check the following replacement steps as reference: 1. Remove the connection of the heating wire, loosen the hook nut of the radiation plat

1.The heating time of the glass tempering furnace needs to vary according to the actual situation. Different sizes of single glass sheets and the number of sheets placed in each furnace will have a significant impact on the heating time. Therefore, appropriate adjustments need to be made according t

1.When there are 5 seconds left in the glass heating timer, the rear furnace door open 2.When the rear end of the glass is 800mm away from the third roller near to rear furnace door when it is discharged from the furnace, the servo motor starts to lift the arc 3.The glass runs forward until it reach

1. Glass-broken inside heating ovenDuring the production process, especially when tempered thick glass it is common for the glass to explode inside the furnace. Once this occurs, please stop the main driving system immediately and manually shake the glass out of the furnace. Then raise the upper par

1.When there is a deviation in the curvature parameter setting or when the glass deviates during movement, it will cause the curved tempered glass not match and the diagonal of the glass to not be in the same plane; At this moment, we should adjust the arc curvature and correct the position of the g