Solutions for Glass Tempering and Processing Challenges

How to choose a high quality glass tempering furnace As you know, for one glass deep processing factory, glass tempering furnace is the last and biggest processing machine. And it is also the largest investment for the factory, so it is the most important thing to choose a high quality glass temperi

If the flatness of tempered glass is not good, it will cause reflection optical deformation of the glass, and on the other hand, it will also produce optical distortion. When used in laminated glass, it can also cause optical deformation of the laminated glass, further affecting the visual effect of

When you want to buy a glass tempering furnace, first, you should consider following things which will help you to choose a suitable machine. 1. Capacity matching:The production capacity of the glass tempering furnace should match the estimated annual comprehensive output.For example, for LV-TFQ2850

1. Blower Installation requirements1.1. Outdoor fans should be protecting by canopy. Prevent lay up fans in open-air1.2. Inspect every parts of fan carefully, to confirm whether the right specification and type of fan. Whether the impeller is in the right direction or not as requirement and whether

fault lies, reasonable repair and exclude, to avoid damage and safety incidents.1. Fan vibration is too large1.1. The impeller is excessive dust, overdose dirt, corrosion or war and tear caused by balance lapsed.1.2. The impeller and the volute or duct contact deformation.1.3. Loose rivets connectin

First checks which we made was made on hot furnace:1. Blowers of convection, does it work right hZ, does it switch on/off on right time of the cycle. Everything works fine.2. Heaters. Resistance and load of each heater. Everything is ok.3. SSR which are switching ON/OFF heaters. It works fine.4. Tem

Is it necessary to choose top and bottom force convection system for glass tempering furnace?Not necessaryForce convection system is mainly used to temper the coating glass, especially for procesing Low-e glass.because there is one coating layer for coating glass, and this coating layer is upper sur

Tempered glass mainly uses physical or chemical methods to form a compressive stress layer on the surface of the glass and a tensile stress layer inside. Just like everything else, the quality of a product is closely related to the production equipment. Only when the production equipment is in good