Solutions for Glass Tempering and Processing Challenges

The ceramic rollers of the glass tempering furnace can be cleaned with water, but attention should be paid to the water temperature, water quality, and cleaning method to avoid damage to the ceramic rollers.As a key component in glass processing equipment, the cleanliness of ceramic rollers in glass

1. Blower Installation requirements1.1. Outdoor fans should be protecting by canopy. Prevent lay up fans in open-air1.2. Inspect every parts of fan carefully, to confirm whether the right specification and type of fan. Whether the impeller is in the right direction or not as requirement and whether

fault lies, reasonable repair and exclude, to avoid damage and safety incidents.1. Fan vibration is too large1.1. The impeller is excessive dust, overdose dirt, corrosion or war and tear caused by balance lapsed.1.2. The impeller and the volute or duct contact deformation.1.3. Loose rivets connectin

First checks which we made was made on hot furnace:1. Blowers of convection, does it work right hZ, does it switch on/off on right time of the cycle. Everything works fine.2. Heaters. Resistance and load of each heater. Everything is ok.3. SSR which are switching ON/OFF heaters. It works fine.4. Tem

Is it necessary to choose top and bottom force convection system for glass tempering furnace?Not necessaryForce convection system is mainly used to temper the coating glass, especially for procesing Low-e glass.because there is one coating layer for coating glass, and this coating layer is upper sur

Tempered glass mainly uses physical or chemical methods to form a compressive stress layer on the surface of the glass and a tensile stress layer inside. Just like everything else, the quality of a product is closely related to the production equipment. Only when the production equipment is in good

For the problem of white haze caused by ceramic roller, normally, you can try to solve it by following way: 1.Maybe the ceramic roller is dirty, pls clean the ceramic roller2.The bottom heating temperature is high, pls reduce the heating temperature for bottom little3.You know, there is one thermal/

Most glass processing factories use horizontal tempering furnaces to produce tempered glass. What are the requirements for temperature control in a glass tempering furnace when using a horizontal tempering furnace? Simply put, there are two basic requirements.1. The temperature of each part of the g