The production process flow of bent tempered glass produced by soft roller crosswise bending glass tempering furnace

1.When there are 5 seconds left in the glass heating timer, the rear furnace door open

2.When the rear end of the glass is 800mm away from the third roller near to rear furnace door when it is discharged from the furnace, the servo motor starts to lift the arc

3.The glass runs forward until it reaches the first roller on the outer side of the bent quenching, then move back. During the glass running process, the lower quenching will continue to change the arc until the arc is in place

4.After the arc is in place, there is a blowing delay (allowing the glass to form), and the shutter is opened to start blowing and cooling until the glass is tempered and cooled

5.When there are 12 seconds left in the cooling timer, the bend section shutter closes and the air release valve opens. When there are 6 seconds left, the lower quenching is flattened

6.After the cooling timer ends, the glass moves to unloading table (the upper air quenching maintains stationary throughout the entire blowing process), and the frequency of the quenching decreases to the standby frequency

7. After the glass and thermal timer have ended, restart the above cycle