Solutions for Glass Tempering and Processing Challenges

1. If the glass breaks during the quenching period in the air grille after it is released from the furnace, it means that the heating temperature is too low or the heating time is too short, causing the residual stress in the original piece not to be completely removed, or the surface temperature of

If the end of the glass tempering furnace's air quench is blocked or the glass is broken, it will cause damages to the aramid kevlar rope. This makes the aramid kevlar rope need to be replaced in time, and the aramid kevlar rope needs to be wound. In the existing technology, the winding of the arami

Two heating chamber glass tempering furnace mainly consists of:Loading tablePreheating ovenHeating ovenQuenching sectionUnloading tableControl systemBlower system The temperature of the preheating section (low temperature section) is generally between 450-500 degrees, and the temperature of the high

After tempered by glass tempering furnace, glass will undergo certain optical changes, especially when installed on the curtain wall, there will be optical distortion. We can take some methods to reduce the optical deformation of curtain wall glass: 1. Improve the flatness requirements of tempered g

1. If the float glass sheet contains nickel sulfide stones. It can cause glass broken inside oven, especially for thick glass, so using high-quality raw glass is a basic requirement to avoid glass-broken inside oven. 2. During the cold processing stage of glass raw materials, if the glass does not m

1.When the coupling between the motor and its reducer is not concentric, vibration will occur. At this point, we should check the concentricity of the coupling and reinstall or replace it.2.When the bearings of the blower motor or reducer are damaged, the blower will also increase vibration. At this

What should be done when there are friction scratches on the glass surface during the processing of tempered glass in a tempering furnace and SO2 gas needs to be used?1.The function of SO2 gas is to act on the surface of ceramic rollers, forming a protective film layer to ensure the smooth moving of

There are more and more types of ceramic rollers on the market, and their sizes also vary. Therefore, when users choose ceramic rollers, they should choose according to the actual situation, and when choosing the type of ceramic roller, they must consider the size of the ceramic roller. This is beca